ชุดแปลงมอเตอร์ล้อหน้าจักรยานไฟฟ้า 26 นิ้ว พร้อมเกจหน้าจอ Lcd
❤❤❤ Welcome ❤❤❤
★ Look at the store and get some special photos.
★Your support is our biggest motivation.
★We will give you the most comfortable shopping experience.
★Perfect after-sales service you can buy at ease
Feature:
1. Adopt high‑quality nylon tires alloy rims and stainless steel spokes rugged corrosion‑resistant and durable.
2. Brushless gearless hub motor with super power. The throttle with battery level and power‑cut off.
3. LCD display shows the battery level and pedal assist settings clear and intuitive easy to read.
4. The brake lever will safely cut off the power to the motor. Crank speed sensor for pedal assist.
5. Aluminum alloy powerful controller high sensitivity stable and dependable performance.
Specification:
Item Type: Motor Wheel
Material: Nylon Tires Alloy Rims Stainless Steel Spokes
Voltage: 48V
Installation Position: Front wheel
Mounting Instruction:
1:1 Pedal Assistance system
Removing the the pedal crank arm and gasket(right or left). Place the receiver ring into the axle and secure it in position using gasket (your bikes own) or superglue. Pay attention to the direction of arrow.
The brake lever is only intended for cutting off motor power supply.You need to connect your brake lines to the brake lever to get a better braking effect.Ensure the iron buckle is closed.
Wheel Installation Installation of the tube motor is the same as that of the hub motor. Please remove the front wheel or rear wheel on your bicycle with a wrench in advance.
1. Confirm the rotating direction of the wheel and install the wheel into your bike frame. Push down the wheel to make sure that the wheel axle is locked tightly into frame
2. Tighten the bolts and make sure it is very tight. This is for safety reasons and this is a very crucial step to build a good Electric Bike. The torque of the motor is very powerful which is why you must make sure the bolts are tight enough to handle it.
3. Install the plastic back to the wheel axle.
Twist Throttle and Brake
Remove the original handlebar grips and brake lever on your bicycle before you carry out the installation for the throttle.
1. Side the brake lever to the handle of your bicycle.
2. Secure the brake lever with an hex key.
3. Slide the throttle to the handle ofyour bicycle and the secureit with an hex key.
4. Connect the bike brake line to the new brake lever s iron bucle.After that make sure the iron buckle is closed. The throttle is installed on the right side of the bike using 3 mm hex wrench tightened.
Package List:
1 x Motor Wheel 1 x Control Box 1 x Instrument 1 x Frame Bag 1 x Throttle Handle 1 x Handle Sleeve 1 x Braking System 2 x Junction Box1 x Line Pipe 3 x Wiring Harness1 x Sprocket 1 x Manual
Note:
For your safety please turn off the battery before connecting the controller.
#MotorWheel #FrontMotorWheel #MotorConversionKit #TwistThrottle #26inMotorWheel #ElectricBicycleAccessory